UN082 mount at lobstermount.com north augusta, SC 29841

UN-327 Suction Base

  • UPC - 181741000327
  • Packaging - Clam Pack H10" x W5" x D3" or Box H4" x W4" x L8"
  • Weight - Unit 0.6 lb. / Case 16.4 lbs (24 per case, L21" x W14" x H12")

Features: Suction Base Only! If you are already using a Bolt-on or MC/ATV base, this allows you to easily transfer your device to your car or any place with a smooth surface. Our Suction Base is a sturdy platform with the capability of tilting for even more versatility in mounting your device. This base, like our other products is produced for use in aviation and marine environments where being compass compatible and corrosion resistant are important.

UN-327, SH-334, and SH-341 Suction Base Instructions

Suction Base Features and Instructions: This base, like our other products is produced for use in aviation and marine environments where being compass compatible and corrosion resistant are important.

To apply: This base will adhere to smooth non-porous surfaces. Choose the location where your device will not obstruct your ability to use the controls and switches needed to operate your vehicle, and also be certain your visibility is not impaired. The mounting surface should be clean and dry.

  • Place the base where you want it, orientated to utilize the features needed.
  • With the throw-over lever in the down position, press the central button to the bottom of its travel, then rotate the throw-over lever to the up position, above the central button. The base is secure.
  • By loosening the knob on the side, the position of the ball may be tilted to some extent, giving you more choice in locating your device. When everything is located the way you like, tighten the knob on the base so it doesn’t allow the ball to change position.

To remove:

  • Either remove your electronic device from the holder or grasp it to prevent it being dropped. Rotate the throw-over lever to the down position.
  • If the base suction has not released, grasp the pull-tab on the edge of the suction cup and pull away from the mounting surface.

Maintenance: For the greatest longevity, the suction mount should be released from the surface to which it is mounted when it is not in use. Also, we recommend periodically wiping the attaching surface with a mild soap solution and then remove the soap film.